Model: 0101-0260

STEP 1. Remove all contents from the received box and check stainless steel tube for any dent. Also verify all brackets and bolts against the parts list.

STEP 2. Read installation manual and installation drawing completely. Understand all brackets and bolts before installation.

STEP 3. Remove driver side front original body mount bolt. Install front mount bracket using M12-1.75x130mm hex bolt, M12 lock washer, M12 flat washer and two 1.88” spacer washer. (Note: Make existing washer and rubber bushing in place).

STEP 4. Repeat step 3 to install center and rear brackets. When installing center bracket, place three 1.88” space washers between bracket and existing rubber bushing and washer as shown.

STEP 5. Fasten step bars to front, center and rear bracket using M-14 bolts and M10 self threading bolt as shown. Torque M14 bolts to 65 ft-lbs and M10 bolts to 30 ft-lbs.