Model : 0102-0193

STEP 1. Remove all contents from the received box and check stainless steel tube for any dent. Also verify all brackets and screws against the parts list.

STEP 2. Read installation manual and installation drawing completely. Understand all brackets and screws before real installation.

STEP 3. Remove the existing body mount bolts from underside of cab on driver side. Install front mount bracket and rear mount bracket with the original factory bolts. Leave bolts loose.

STEP 4. Bolt mount brace to the bottom of vehicle frame using M12 – 13 x 190 mm bolt, M12 flat washer, M12 lock washer and M12 hex nut. This is only needed for the 4WD model.

STEP 5. Fasten driver side step bar to mount brackets using M14 hex bolt, M14 lock washer and M14 flat washer. Tighten torque for M14 and M12 bolt t is 60 ft/lbs, M10 bolt is 30 ft/lbs.

STEP 6. Repeat the same procedure for the passenger side installation.